daewoo matiz immo off

[tuning73]

help kids are 2 days that I fight with a matiz control unit kemsco d3 does not start error in the ecu 2 "incorrect calculation and immobilizatore"
I've done everything in my possession, but still not changed the box code put new chip keys, nothing the same error

[legendaryslave]

tried to do a partial on the 29f200

[Already]

If not remember bad for those of us wants the e xxx. Go with that and you take out any problem

[motorsport]

I confirm the total, nothing,you can do only partial,we want to emulator!!

[tuning73]

already tried scodifica partial 2 times


I confirm the total, nothing,you can do only partial,we want to emulator!!

I also put in the emulator, the same thing is not part ilprobleema and even after you've changed the box code and made new keys put the ecu virgin I still have the same error "no response to the release" on the ecu and immo on the engine control unit, which now marks the ecu virgin I have a error immobilizatore and incorrect calculation I would not like it's really the ecu that went

[motorsport]

OK have you done the new keys,but you have done the fit with the diagnosis??? if you have the Texa do it without problems!!!

[Already]

A stupid question.... After the installation of the emulator code, you have detached the immobilizer?

[Gerard]

Emulator for daewo autocode and cut immo pin on the ecu, made dozens and-games-to-first shot
Another thing, if you unplugged the flash make sure that there are no residues of the resin, otherwise the welds could create some problems

[tuning73]

A stupid question.... After the installation of the emulator code, you have detached the immobilizer?

sure, I have put the emulator as shown in the diagram inside the ecu cut the pin 56 (which if I'm not mistaken, and also the thread of the k-line diagnosis) equal to is not part


Emulator for daewo autocode and cut immo pin on the ecu, made dozens and-games-to-first shot
Another thing, if you unplugged the flash make sure that there are no residues of the resin, otherwise the welds could create some problems

you flash the detached 2 times, checked the pins one by one the welds are perfect 1 question, but with the emulator seve put it virgin or don't need ? Tuesday I get a new ecu I have to scodificare to put the emulator or also coded ?


OK have you done the new keys,but you have done the fit with the diagnosis??? if you have the Texa do it without problems!!!

I have done 20 times the adaptation of the texa is the whole procedure but the same thing does not start a thing that I have noticed that after adaptation with the texa and obviously not the part I re-read the file inside the box code and is not changed anything that I had written it myself so I think that the procedure is not working

[tuning73]

I'm becoming crazy, I put another ecu (I don't know if that also fails, too ) the same problem immo active, and not even with the emulator who gives me some solution aiutooooooooo
I confirmed that with the emulator should start in the control unit, and a kemsko d3 cut the wire 56 immo mounted emulator siaccende the green led flashes 3 times red led (on the emulator) will turn off but the bastard will not start :confused:

[Gerard]

You have to do is solder the three wires to it, if the emulator ? what of justice ? autoapprendente and the flash does not need to touch

[tuning73]

status. final
the car and the game, the problem was the engine control module replaced and the game with no problems, but I have to say that emulators that sell chinese do not work I have tried different and not go with the ecu coded and also the virgin is not put in motion.
thank you all for the answers, greetings