Opinion maps 156

[paolo159]

Hi guys,
a friend has asked me a hand to fix his car, a 156 1.9 mjet 140cv since? the smoked-type train coal turbine has begun to whistle tremendously...
I extracted the map from his car and look what I found! ? among the attachments 156_PRIMA_MAPPA
it seems to me a piece of junk incredible, nothing more? malicious is for the poor turbine to the pocket and seen that it consumes like a ferrari!!!!

In order to save the savable, I remade I the map pretty quiet since the turbine ? to review, it has my map for about a month and told me that the car ? reborn, much more? ready (in the previous had not touched the map with the pedal), consumption halved and the whistle of the turbine ? reduced a lot.

I'd like to know what are your opinions on both maps, but especially on the first visa that I don't understand the logic with that ? been made.

[tidus1985]

then he touched on things that probably don't even know cos'?, changes via drivers are very low, maps pedal original, already here you understand the knowledge of the funionamento ecu, low, you say ok, I will change the map tinj so I don't have to change the maps, the pedal is ok but must be made calculations on the basis of how you want the car and where you want to be in a certain way, but with increases of 2% to 4% do not go away, moddati the prex turbo, and not the limiters, advances the absurd for the little increase, 3.5? not to them do I with almost 100mm3 injected...
for your mod, we apply the advice on another post, remove the useless mods out driver made by him, nanticipi have them modified to the contrary, at higher rpm, and well give less, and from 2000 to 3000 more

[paolo159]

tidus thanks again for the great advice, when I made the corrections on that map I was in a hurry and I did it just right you need that? the machine didn't blow up in the air turbine :-)
from the diagnosis I have seen go up the prex goal at 2900 mbar :-D even if I do not explain how this is possible, since lim not to touch them...

I had not realized that they had been touched by the values out of driver, now I see my version and I do to fix it up a bit...

he thinks that the guy who made that map ? very popular here in the area...if he ? a trainer I have invented the common rail ;-)

Tidus I do not quite understand what you said about the timing of injection...
to anticipate, I must decrease, right? then I can give from 2000 to 3000 -1 degrees and 3000 in about-0.3 and for example? I understood well?
clearly ? as an example only, then the values should be proportioned on the basis of the increments of the injection times.

I tried to redo the map...always quite soft and I cleaned up the mod out driver
what do you say?