fiat stilo 1.9 egr problem

[michele30]

I have a customer that is only a problem power light engine every so often and not diagnosis it gives me an error p0404 signal is not valid, however, I was also told that this machine ? liked the map and disabled the egr, then I read the map and comparing it with the original I saw that the egr ? closed well.
to eliminate the power of the light what should I do, change only the electrical part, or else I can do to the map?

[alfajtd]

almost closed a few bits in the end ? correct

? normal and still have the error closed cos?...

if the light comes on it could be that the electrical part is ruined...

[michele30]

? normal to get the error in diagnosis, or ? normal that every time you turn on the light by turning off l egr?
which bit are you talking about?

[SandroMarciano]

disabling the egr, the lamp should not illuminate, the maximum fine is the error in diagnosis, however, if the file you switch it off with the switch.

Sorry, they are outside, test if d? error with this. p.s. remember to disconnect the plug and leave it unplugged!

I apologize infinitely for the triple post, but ? important: calculate the checksum before writing.

[alfajtd]

? normal to get the error in diagnosis, or ? normal that every time you turn on the light by turning off l egr?
which bit are you talking about?

? normal to have error in diagnosis without having to turn on any light with the change of the straight line.
if no c'? another way of disabling the EGR as in the file that you have passed, if the bit touched ? the right one, I have not seen the file,
and as c'? written correct before writing the checksum.

[michele30]

now, I can't upload it, I don't have the machine, however for now I changed the electrical part of the valve with another to see if it goes well.
sorry but where is the edit on this file?
not known differences by configuring it with the ori

[SandroMarciano]

c'? just a bit, changed to 8, in this way, the machine does not use pi?!

[leandro89]

regardless, I think that the injection phase you must bring up to 12000 and non-12740

[msport (exil77grande)]

regardless, I think that the injection phase you must bring up to 12000 and non-12740

looks good to the maximum value in a table that is not' 12000 but 12740,for the rest is missing just a bit at 12740 that turns on every so often, the failure diagnosis of the edc15 it is normal that give the error by excluding them from the map phase injection egr.

[leandro89]

wow in the top right, there is the value of pi? the top of the 12000 I hadn't really made the case, in general the max value ? in the lower dex, do? pi? attention the next time!

[Exside81]

On the stylus x to close the egr brings you everything to 12740 look of a table.and should not give any light to the maximum in the diagnosis you get error egr. If it turns you on, and that nn v?, or and a mltijet