Sign in

View The Full Version : info opel corsa


legendaryslave
21-04-2013, 16:52
hi to all the forum after they have smanacciato with this car opel corsac 1.2 16v year 2005 engine z12xep ecu bosch me 7.6.1 I find the following problems in the engine control unit, the following faults p1615 vehicle identification unit body p1616 vehicle identification unit tools U2018 no communication with abs/tc, diagnosis body U2103 fault can bus fault bus V U2104 counter reset can bus passed u 2105 no communication with ecm u2108 no communication with abs/tc.
to the car ? replaced the motor and wiring taken from another car in the demolition and gave a myriad of errors I did restore the wiring ori and I are compartments all the errors but I still got the above as you advise me to proceed, of course, this ecu can not do the total, any advice ? welcome, thanks in advance for the advice.
carlo abarth
21-04-2013, 18:57
the machine that makes you the part and die???
legendaryslave
21-04-2013, 20:03
it starts and dies very probably the problem with immobilizer
carlo abarth
21-04-2013, 20:26
have you tried to remove the picture (tacho)and re-enter the pin behind!!!!
legendaryslave
21-04-2013, 20:49
no not really I want to try to put the frame back and the immo in the ecu the engine, but the car pass you can derive from the reading of the block
carlo abarth
21-04-2013, 21:53
I just think opel!!
legendaryslave
21-04-2013, 23:49
I just think opel!!

and if I do a letturra of the immobox and from them I obtain the pin can also go
explode82
22-04-2013, 11:08
hi legend,can you? make it safely and without problems already done ir? times,but you also need an opcom to do the adaptation of the immobox.........for the carpass c'? a procedure
legendaryslave
22-04-2013, 21:20
explode82 the hell with that I managed to read the immobox I sent the customer opel with the booklet or expected to get the carprog
explode82
23-04-2013, 01:06
do you know that ? na something very very strange this
legendaryslave
23-04-2013, 12:57
we found the car pass now I try to re-encode the
carlo abarth
23-04-2013, 14:29
through????opel???
we found the car pass now I try to re-encode the
legendaryslave
23-04-2013, 21:12
through????opel???
no, from the reading of the painting is made with the opcom
legendaryslave
30-04-2013, 21:58
after a bit of swearing, I managed to put in motion I am the calvary, car solution replaced the ignition keys body engine control unit and the framework I have gone from a system me7.6.2 to a system of m 1.5.5 as the engine came from this generation, aligned all the ecus changed the wiring now it's turning