File conversion from 2 mb magpro to gallo 2 fgtech 1mb

[hackgen]

Hi guys,
I would like to write my modified map with the cock 2,
only that tells me the size is not correct why? the file ? 2mb
to write with mag pro.

My car ? a audi a4 140 8v 2007,
I tried to use the cut/paste of the ecm
and set the last block manually to 0FFFFF the file
generated actually in the size of 1 mb for?
while the original file is read with the Ecm information:

Bosch
1037382430
------------------------------
Cks: 85A6
Size: 2097152 = 0x200000



That cut me from "Info not found".


? evil cut? Can I write it anyway?

What's wrong?

Thanks

[legendaryslave]

read and write with the same tool

[hackgen]

You're right legendaryslave,
but ahim? the ecu is giving me an error reading from the serial port the map I have ? that and I wanted to use it,
trying to write if no I have to disassemble it for the bdm.

Then, however, I wanted to figure out how to do it if feasible.

Thanks

read and write with the same tool

[giuseppe1374]

but you have selected the correct driver?

[legendaryslave]

that ecu ? u1-u34 having the file 2 mega're likely ? a u34, not to write the file cut to a mega you can block try to do a reading with another tool

[giuseppe1374]

in fact, if ? 2mb does it say that ? a u34 but it seems strange to me that the gallo2 does not have the driver, according to me he has the wrong driver

[giuseppe1374]

I forgot to say that I did passat 3c and golf5 with the same ecu and upload the file to 2mb with gallo2

[legendaryslave]

I forgot to say that I did passat 3c and golf5 with the same ecu and upload the file to 2mb with gallo2
now ? later there was the piantamento of the ecu

[giuseppe1374]

tourist diy? no alpitur? these these have!