View The Full Version : read and write nissan qashqai 1.5 dci 110cv siemens sid 305 with galletto v2
simone82
05-04-2013, 13:17
hello everyone;today I have tried to read a nissan qashqai 1.5 dci 110cv(renault engine), and reading ? come to a good end,someone of you has already tried to read from and write to a serial port and have not had problems?oh I forgot,this type of ecu has the antituning?a greeting to all users.
Hello
What interface to use?
simone82
06-04-2013, 16:43
Gallo v2 clone european
Hello simon
Do not use this interface (gallo V2), but with cmd is not the only issue.
simone82
06-04-2013, 16:53
That type of ecu l antituning? ?
simone82
06-04-2013, 17:00
Thank you for the info
Hello
Nothing you can do to obd without problem.
simone82
06-04-2013, 17:13
Read without problems, for? before loading it, I asked the opinion of someone else
Hello
It is normal practice to have dude.
gameiruz
26-04-2013, 11:46
Sorry the question, but the SID 305 with galletto only v53 ? that if you can? read from the obd? For BDM obtained with V50 or V51?
thanks
Sorry the question, but the SID 305 with galletto only v53 ? that if you can? read from the obd? For BDM obtained with V50 or V51?
thanks
I have the version v48 (the penultimate), and not the law in serial mode, tried with clone china and europe, I know, but I have not got to try that with the new version V53 you can do....
gameiruz
26-04-2013, 19:19
I have the V48 and V51, but I can not read for OBD and BDM have no proof. Version V51 to V53 I believe that it is only a matter of SW and driver ...
V48 and v51 have the same hw, while x 53 there are 1 versions, one has only the aggioramento firmware and sw is different (this has a limitation as the non-operation of the jtag ...), the other has different hw and sw is different .. and ? the best at the moment ... as soon as I install the update on my v48 and see if it goes on this car..
gameiruz
26-04-2013, 20:13
guidotacco
26-04-2013, 20:39
I don't understand if you are unable to update it!
that sorry I did not understand....
you managed to free the protection of the version v53? have you made this car?
gameiruz
26-04-2013, 20:47
I have not been able to get the software ? protected by a dongle. Also tried with AES Flasher SW but without results ...
The translator ****** not ? very accurate, sorry
I have not been able to get the software ? protected by a dongle. Also tried with AES Flasher SW but without results ...
ahh ok I figured;)
I software v 53 I have it but not ? sufficient to run the galletto v48 ... I think I serve something else...
Clones apart.
With the cock ori I read a renault sid305 serial, in a couple of minutes has done all the work.
I noticed for? I made it just in time to finish the reading, and the machine ? way mode? energy saving! Then I didn't trust you to write it...
Does anyone know how to make them stay always active?? In the boot there? been no way to read it, do you know why?....
Clones apart.
With the cock ori I read a renault sid305 serial, in a couple of minutes has done all the work.
I noticed for? I made it just in time to finish the reading, and the machine ? way mode? energy saving! Then I didn't trust you to write it...
Does anyone know how to make them stay always active?? In the boot there? been no way to read it, do you know why?....
I have the v53 phew... and a week ago I read a sid301 and I sent the file to f.g. and they assured me that ? perfect and I can write safely
.....I say this because even this scenic II of 2008, the read-in serial and me ? attached to the fan after the 28% of reading, and the done finish.....
my sn to realize that you do not ? off even the picture so I gather it is not working vadi off....
anyway, the scenic make even sid 305 and I think the situation is the same.....
anyway, one thing that you have to make the motors renault you write and say unto you, all with a water temperature below 50? otherwise, do not start more.....
and the keys anyway inserted in the appropriate slide or next to the picture if it has no insertion
excuse me, I said bullshit that is, the sid 305 is not the view in the renault, but in the protocol of the nissan that is in tricore.....then on the sid 305 clear all...
one thing however what can I say about the sid 305 renault,,, your problem is not the you can read in the boot and this...
.ECU Siemens Continental SID305 HW01 - TC1766 Internal Flash...,,
that sn two versions of sid 305 the second and:
ECU Siemens Continental SID305 HW02 - TC1766 Internal Flash,,,,it is only in this way:
:This ECU has a hardware slightly different from the previous one and in the pinout at the pin D1 we need to give 12V instead of the Igniction
With regard to the mode? energy saving, I've found even on a renault edc16! and I made it in BDM, since? the reading was interrupted! When they come in energy savings in fact, vine is rising even power to the ecu. Same thing to me ? happened on this sid305: if I take too long to set up the cock, and save the file, it does not time to finish reading the serial port. Then put the case that it takes 30 seconds longer to write than to read, you plan everything!!
As far as the boot, talking with Adolfo I have already? the tests of the case: my would be a HW1, but I also tried with the pinout of HW2 and always gives me the ecu is not in the boot!
That the nerves.
carmageddon
11-06-2013, 09:42
for all cars with keycard, or still key, bluetooth, c ? the procedure to keep it turned on without exercise of the stand-by that takes away power.
for all cars with keycard, or still key, bluetooth, c ? the procedure to keep it turned on without exercise of the stand-by that takes away power.
Which one? Do you know how to do it? You could post so we all know something new...thanks
carmageddon
12-06-2013, 08:31
Megane:
To turn on the picture: do not touch the pedals, put the gearbox in neutral and press the Start button and finch? the picture does not come on and it clicks the rel?.
To turn off the picture: crush two times the Start button and remove the card (card), otherwise the vehicle will not turn off completely.
Laguna:
To turn on the ignition: on vehicles equipped with manual transmission, engage first gear, while on vehicles with an automatic transmission put the lever to N (Neutral). Press and hold the Start button finch? on the display appears the message, remove the card, but do NOT remove the card, otherwise the picture will turn off.
To turn off the panel: remove the card (card).
Megane:
To turn on the picture: do not touch the pedals, put the gearbox in neutral and press the Start button and finch? the picture does not come on and it clicks the rel?.
To turn off the picture: crush two times the Start button and remove the card (card), otherwise the vehicle will not turn off completely.
Laguna:
To turn on the ignition: on vehicles equipped with manual transmission, engage first gear, while on vehicles with an automatic transmission put the lever to N (Neutral). Press and hold the Start button finch? on the display appears the message, remove the card, but do NOT remove the card, otherwise the picture will turn off.
To turn off the panel: remove the card (card).
Ok thanks for the info you have taken a big problem....of course
Megane and better than even the scenic II....
Megane:
To turn on the picture: do not touch the pedals, put the gearbox in neutral and press the Start button and finch? the picture does not come on and it clicks the rel?.
To turn off the picture: crush two times the Start button and remove the card (card), otherwise the vehicle will not turn off completely.
Laguna:
To turn on the ignition: on vehicles equipped with manual transmission, engage first gear, while on vehicles with an automatic transmission put the lever to N (Neutral). Press and hold the Start button finch? on the display appears the message, remove the card, but do NOT remove the card, otherwise the picture will turn off.
To turn off the panel: remove the card (card).
Always a pro !
Thanks.
:D
carmageddon
12-06-2013, 18:46
hello Charles!
thanks :-)
msport (exil77grande)
12-06-2013, 22:43
however, for those who work with the kess v2 the procedure is written.
should enter my a nissan,I have already seen? mounting a sid305, I ask you to avoid misunderstandings: with gallo v50 is not f
dvdtuning
17-10-2013, 16:34
should I do a megane coach 3 1.5 dci 110cv with sid305, kindly can you tell me where? placed the unit why? I would like to read it in the boot?
I assume in the engine compartment, visible on the right, and at least 2 Megane views for other reasons had them...
dvdtuning
17-10-2013, 18:38
also I had seen a previous model had under the compartment batteria...su this is no good, should I disassemble...
dvdtuning
17-10-2013, 18:46
these fap should bucarli or to empty them?
dvdtuning
18-10-2013, 21:06
I think it is impossible bucarlo..***** s read-in and serial in the boot, and written in serial with rooster v53, do not attack the fans, but the eye to the picture, I tried what is written by carma but it was not working, in fact ? nailed the write to 48%.
I entered the march, every 30 seconds would bring myself down on the brake and start button and the picture would always be turned on. Writing in the serial takes the double of reading, reading 2,30 minutes and write about 5 minutes, and then I wrote back and ? come to a good end.
I read a sid305 with cock v54 clone,? I can not find addresses egr to release it, who knows how to do it? Help!!
dvdtuning
06-06-2014, 17:59
I read a sid305 with cock v54 clone,? I can not find addresses egr to release it, who knows how to do it? Help!!
Online service, surely you can help
Errecinque
03-11-2014, 13:09
Megane:
To turn on the picture: do not touch the pedals, put the gearbox in neutral and press the Start button and finch? the picture does not come on and it clicks the rel?.
To turn off the picture: crush two times the Start button and remove the card (card), otherwise the vehicle will not turn off completely.
Laguna:
To turn on the ignition: on vehicles equipped with manual transmission, engage first gear, while on vehicles with an automatic transmission put the lever to N (Neutral). Press and hold the Start button finch? on the display appears the message, remove the card, but do NOT remove the card, otherwise the picture will turn off.
To turn off the panel: remove the card (card).
Confirm that the procedure megane ? the same for the scenic? Cos? just to be sure before I read the flash with cock v54. And anyway, to be held for the duration of the operation, or can you? release the ignition? Thanks
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.