Info on this file Toyota

[pitty]

Hi guys,

some good pious soul could tell me what I should change, and any percentages that according to you in a car like this I should change??

I could write it quietly without making a backup? In theory I know already? that I could write. I have the galo 2!!!

[magi1984]

discussion moved, not center a bat in the section of motor VEHICLES
pay attention to where open discussions

[pitty]

excuse me. you are right. I remembered that there was a section dedicated to it but not found it!

[msport (exil77grande)]

I have personally, this machine is my wife and has the classic areas to be modified injection type split,rail pressure,leakage limiter rail,torque limiter, and a few other things, nothing of that,the only advice I can give you seen the personal experience and that here to have a normal result you need to increase a bit more than usual,however, you can write quietly in serial with your cock v2 also because to have a backup you have to unsolder the flash or link it to the bench and not worth it to go quiet.

[pitty]

Thanks a lot,

my doubts came from the fact that in the driver I found with the same name, or almost:
injection paralyzed OK
injection correction-OK
then there are:
injection zoned MAP 1 and MAP 2????
injection zoned MAP 1 and MAP 2 (BOOST, RPM)????? (it should be
then c'? the classic
torque limiter OK!!!
Rail pressure and limiter rail, what are they? the maps with the MAP was written 1 and 2 and MAP 1 and 2, BOOST and RPM limiters?

[pitty]

I forgot:
I know that the MAP 1 and 2 should not be touched since? there may be advances! I remember well?

[pitty]

sigh sigh...

no one can tell me anything? all is silent?