Clogging degree

[egs]

Hi guys, the other night I defappato a 159 1.9 JTDm 8V 120 hp with ecu Bosch EDC 16C39, HW_0281015163 SW_1037398255, with ecusafe, read tour and so far everything is simple and ok. I write the file in the ecu, and provo. I do a diagnostics to check the egr and the values of the fap and the clogging was at 0%. I'm going to go for a ride and everything is ok, I go back in the workshop, make the diagnosis, and I see the clog to 1000%. I take the file to the control and, in fact, the sw had also changed 1E46EE a bit, I'm going to see on the chart, and I find the curves that are also in the manual of the forum, then I edit the file and fill the values as the original, except for, and to compare the files and the curve is lowered as in the manual. I write the file I do the diagnosis and the clogging was still 1000%....!! It never happened to someone....????

I attach the files ori and mod for a comparison.

[alfajtd]

ecusafe on some of the sw busts a address the negative -6 if I'm not mistaken... it should be the last address that tap... what ? the volume of the DPF

you have to put it back to the original......

to the lighthouse to appear again at 0%, you should do sost.DPF through diagnosis

[egs]

The address of which I speak ? the last....and I reported the original data....

[alfajtd]

I would take cos? that ? the way pi? logical,
replace the original map, do sost. DPF diagnosis, replace the map without the DPF.

Cos? doing it you will have all the parameters to zero.

[egs]

Mmm......For another, the machine does not ? even in the workshop now....

[alfajtd]

Nothing will happen.... then back systems.
If you're lucky with the correct data entered, you may adapt by only covering a lot of miles...
But you can ascertain for yourself.

[egs]

You, my doubt now was if I changed some of the data that pertain to the regeneration, but I don't think....

[msport (exil77grande)]

You, my doubt now was if I changed some of the data that pertain to the regeneration, but I don't think....

I wanted to understand why you opened this discussion off-limits.

[egs]

Sincerity????? I didn't know where to open the discussion...but what do you think?

[msport (exil77grande)]

I think that this is a particular section and not for everyone, and if you open similar discussions here do you not understand much.

[egs]

No No... I understand.... The manual of the degree of clogging ? in the section off-limits, and I thought I'd open the discussion... but I don't think I have created any major problems, the rest have also moved... anyway, I apologize for the inaccuracy!