Knock sensor smart

[usardaun]

Hello guys yesterday I did a diagnosis with autocom on a smart petrol, 2001, result in an error 06 knock sensor!!! someone can? give me some advice?? where I'm sensor?

[Backgroop]

is attached to the one-piece in the back of a casino take it apart, I would recommend you check out the connectors..
attention is not always the knock sensor, sometimes there are some problem with the engine, the cio? turns bad or not good..

[usardaun]

But no, that part is good, the only flaw that it has, ? I use a bit of oil!

[usardaun]

Has anyone had the same problem?

[michele30]

those machines all consume oil, what not ? a problem only your.
for the knock sensor, make sure that you check the wires as said backgroop and on the sensor there is of oil ( dirty with the oil of the engine )

[munro]

check the spark plugs....many are limited to only change the 3 spark plugs superiors, not knowing that the smart twin spark....
then have 6 candles....then check the 3 candles, lower.... at least if we talk about smart first series....

[neo]

Also, according to me, this is not a sensor fault.This error came out because the knock sensor registered a detonation out of the norm.I confirm that I check the wires and spark plugs

[usardaun]

Monday? I'll have a look, the candles have covered about 25,000 km!!!

[neo]

I don't understand but if l error you are unable to cancel, and if it appears again after deleted?

[usardaun]

no, not me erase it with Autocom!

[neo]

At this point, change the address .You need to check the wiring or the sensor .Hello and good Sunday

[neo]

Another thing ;if the error and P2006 for sure, is that the problem and the wiring or the sensor because this error tells you that there is missing a signal from the sensor

[usardaun]

gave me error 06, knock sensor!

[neo]

I think they sie the same thing .Do the tests I said.Watch ******** l error P2006.

[usardaun]

But that problem can? you give them? the machine the guide a girl and anyway I said that it is okay!! that problem can? give this knock sensor?

[neo]

This sensor records "noise"anomalous, and in case of necessity destinations in the engine recoveri

[chicco]

Not ? said that the place for force in the recovery, can? also simply remove a few degrees of advance or slightly lowering the prex turbo until the "noise"(detonation) does not disappear, ? can the driver not noticing.

[neo]

could not agree more,that was just a sample I made

[chicco]

You I figured it out, I just wanted to note that sometimes, certain strategies may not be felt by those who use the machine, then in this case if the problem ? a power outage is probably not implemented no strategy.