opinion the map alfa 147 1.9 8v 120 hp

[igor]

hello everyone I wanted your opinion on this map that made me a trainer of my area, I have to say that the machine is equipped with a direct intake kit "BMC-carbon dynamic air box", turbine, increased and reinforced provided by the preparer (unfortunately not s? specify model and why? the numbers have been erased, s? only that ? a garret with the flange of the exhaust gases of a triangle) and the exhaust ****** except the terminal, below I am attaching the file ori and map

[igor]

bench test with this map I was not able to exceed 175 Hp, can you? improve or ? the limit for this machine?
thanks in advance

[msport (exil77grande)]

I wanted to give you a personal opinion on your mod,I downloaded it but it has the pass that we have to do?

[igor]

sorry I supply quickly :o

[igor]

sorry no I can? to give an opinion?

[legendaryslave]

mmmm maps pedalele must be the same as increases in the egr valve has no sense of toccatto a few goodies out of the driver management turbo I absolutely love it so, the rail and been done with a certain logic, I like that we would have to do some correction as it goes on the car?

[legendaryslave]

excuse the golds that you posted there is something not right

[igor]

the machine in general is not going badly but feel a void from 3200 to 3700, with regards to the egr, I have already solved it myself, and I was able to exclude it with carsoftware, and it is good, in the pi? if I have to be honest doesn't go as I would like
(I did some tests with other maps made by me (but not the load even on the forum, otherwise all of them end up in the jokes section), starting from its base and I was able to delete the blank and make it pull more?,but I still have problems on the press rails and when I accelerate suddenly from 3000 rpm the car takes off and generates fault code, and the same with the press turbo, arrival at 190Kmh and I from the cutting torque to press the turbo too high, but thanks to the forum st? improving step by step)
with regard to the goodies out of the driver what can you tell me? I also notice I but I got no idea what they are nor what they are, I have marked all the addresses and if someone can? to explain it would be a good thing:
from 1E319C to 1E31A8
1E3268 1E3274
1E0F26 1E0F2C
000000 000010
1CBD8E 1CBD98
1FDFDO 1FE000

thanks a lot to all

[igor]

the cio? what c'? that doesn't square in the gold?

[legendaryslave]

is not riconusciuto from the titan, then the cks not ? ori, I have made many of these car and go really loud then it is evening, calm you of or some straight gold healthy at work

[Chris156]

I also have to work!!! but at first glance it seems that the file ori not ? original.. start by getting the right file and trust that if you, the map will go? much better, if you want then we discuss it together.
Ps: the rail incremented when non c'? request acceleration is nothing.. in the 30mm3 ? needless to abound. you have to work only where it is needed and informed.

[igor]

someone I know say what those changes out driver

[pdtechnology]

hi igor, I hope this can help

1cbd8e-1cbd98 ? a torque limiter
1e3268-1e3274 should be another torque limiter linked, however, with the high pressure pump
as for the other addresses I don't know exactly.....good job hello hello

[igor]

thanks a lot, and someone else could kindly tell me what are the other addresses?
and if it moddarli or are not essential, some of you use them?

[Chris156]

but did you realize that the files you posted are both of the mod? downloaded the file ori and see what they have changed really.