Opinion the map Opel meriva 1.3 75hp......according to me I have the wrong drivers!!!

[Emanuele54]

Hello all,
I made the map of the above-mentioned machine, but I think I have the driver ECMtitanium ciucchi I only see torque limiters and something of the injection, in the pi? using carsoft should I have disabled the EGR......

give me a feedback?

Thanks

[frantik3]

try it you will feel a little difference but not do damage to the egr and closed!!!!!!!!

[motorsport]

I believe almost nothing, the increases are few and there is a lot of maps out of the drv that titan again rest in peace!!

[mafani]

I'm sorry I can't help you for the moment

[msport (exil77grande)]

I'm sorry I can't help you for the moment

I would say to avoid such comments that are not constructive and only serve to increase the counter of messages thanks,I wanted to remind you that I read every day all and I repeat all messages in the forum.

[Emanuele54]

Hello someone has the address in the pi? from change?
could indicarmeli?

Thanks

[jolidj]

the problem nn and have maps + from the tap , and the problem is that even those that you know you have touched evil.
limiters torque by 15%
the injection times 7 % , no, but as you have done (almost on the tt map), but from the 1500giri at 50% load.and you have to frame the map well.
08de86 other lim torque . ( there are also others but these 3 sn + important )
090546 by 15% for the other 3.( the same area).
raises the pressure of the turbo mechanically .
try to let us know.
you are missing the other maps, but I think so can go the better.
try it because you write without having a practical confirmation nn I like it so much.

[Emanuele54]

ok now I change the map and when rivedr? the customer prover?, to make a manual change to the turbo, I have to record the race of westgate?
how much?

Thanks

[jolidj]

how much?? you must have a pressure gauge x see exactly how much increases .

[explode82]

careful that the problem are the peaks by moving the westgate,I will if I have to do a lot of thrusts, I put a particular faucet that makes me control both the fixed and constant

[Emanuele54]

Hello, for now I tried to edit the map......even if the trick of the rubbinetto you could explain it to us....?!



how do you think v? the map?
when I do not have the driver, as the identify with the maps? as in this case of the limiters that I have indicated?


Thanks

[explode82]

and a faucet with double regulation,which regulates the air vents and bare to the settings you have peak and the desired constant

[Emanuele54]

you do not have photos to post in order to make this idea better?

Thanks

[explode82]

I try to on the internet and the place

[explode82]

this ? a link to where he does see

http://www.mjet.it/phpBB3/viewtopic.php?f=15&t=9528

this ? an image of the faucet indicted XD

[explode82]

what have you done then emanele,saw the link that I posted?

[Emanuele54]

Hello, you ? a nice solution.....diy! the customer is deciding I meanwhile I found something similar on ebay in england as I can, I buy one, ela first time that happens to me I install it and try.....and of course, the informer? of the result.

Thanks

[explode82]

I have posts of different and go mene then go quiet