PDA

View The Full Version : resistance the ecu mjd6f3


progress
21-01-2013, 19:55
hello everyone I wanted to ask, how many ohms and the resistance to desolder on the ecu option which is mentioned above? of course, the one described by the book gallo2
progress
21-01-2013, 20:00
the post above and referring to the manual to read the ecu mode bdm
legendaryslave
21-01-2013, 20:06
0 ohms the one that tells you the manual after reading and srittura does not require the replacement
sno74
21-01-2013, 20:46
right on the manual see also the position.....
progress
21-01-2013, 23:16
0 ohms the one that tells you the manual after reading and srittura does not require the replacement
then if it is not risaldata the resistance nothing happens?
ps ... do you know how many ohms and the resistance now I'm curious
thanks a lot



right on the manual see also the position.....

sisi seen the good, the resistance on the two types of 6f3
legendaryslave
21-01-2013, 23:19
progress
22-01-2013, 01:20
I read delay 0
sno74
22-01-2013, 08:20
well you let them welded ? only zero.........
progress
22-01-2013, 08:47
well you let them welded ? only zero.........

this is equivalent only to the marelli, or a bit' for all those who have the strength?
sno74
22-01-2013, 09:20
in the manual explains it all for? I only know marelli.......
alex68
22-01-2013, 12:31
the mtj have the resitor.
giarras
22-01-2013, 12:41
? updated the link to the guide of the bdm, there are all the information regarding this.
progress
22-01-2013, 14:15
but in the updated version does not explain that the resistance can not even put it back and even option which is mentioned is the measure of resistance, at least according to the verasione November 2012
giarras
22-01-2013, 15:32
go to page 26 that the sti is written..and then there are also photos.
nuovaecu
24-01-2013, 20:24
I have posted the pictures that follow you step-by-step
progress
25-01-2013, 13:55
excuse the photos, and where?
giarras
25-01-2013, 14:03
excuse the photos, and where?

progress, the material ? posted in the forum,you no you can see him xch? still nn you have the rights,from a reading of the regulation and you will be? all + clear.
progress
25-01-2013, 18:44
sisi, I have read the regulations, in fact, your reference to page 26 on bdm I've seen, but the references nuovaecu I have not found even obscured
bicio
25-01-2013, 18:46
only marelli ok
nuovaecu
26-01-2013, 11:27
in the forum you will find an illustrated guide on what type of unit you need to remove the resistance and also on the position illustrated with figures