Immo OFF Bosch MS6.2

[jared_poe]

Hi all, I have read somewhere that to remove the immobilizer on these ecu just remove the 24C16 that or highlighted in the picture.
Me confirm?
PS the ecu ? a Iveco Stralis 480

http://img834.imageshack.us/img834/7707/img221c.jpg (http://imageshack.us/photo/my-images/834/img221c.jpg/)

[frantik3]

you have to riprogrammarla should be a 24c16

[jared_poe]

thanks for the reply frantik
so it's not just remove it??
for riprogrammarla what do you use? willem? xprog?

[frantik3]

both are good

[motorsport]

hello,I suggest to remove it from the pcb to make a correct reading,with willem + adapter soic...and go clear so avoid doing some reading wrong, read at least two times the file and check in the esa if they are the same!!

[motorsport]

I confirm that I and a 24c16 you can? do both partial and total with the same file,if you are to make it a total off the immobox,partial all connected!!

[jared_poe]

according to you, with a ludipipo programmer I can run quietly on the job? that sw is used to read and write?

[motorsport]

I never heard of this programmer so I can't help you,however if you take a willem or another, and including also the soft for reading and writing,then you will need an adapter to part SOIC-8!!

[frantik3]

you with ludipipo can't read it!!!!!

[bicio]

it goes very well ludipippo for the 24c16

[Marting]

download the 24C16

[Fabiuz]

But has anyone tried to remove the 24C16 and see if part of the van?
I just have a iveco daily 35C with the bosh MS6.3 to remove the immo total

[sisco]

I also read somewhere that by removing the memory should start, but for the ms6.2, since the need to do test you, so you have to unsolder to read it, when it is down the test as to whether part so we take away the doubt

[Fabiuz]

unfortunately, I have only brought up the control unit.
And are those things that when you return it should work.

[sisco]

unfortunately, I have only brought up the control unit.
And are those things that when you return it should work.

in fact, after having written the message, I thought that could be one of those cases, but now it's done, if I find something you notice

[todos]

if you take out the eprom on the ecu part however......

[sisco]

if you take out the eprom on the ecu part however......
Hello Todos, but only applies to the ms6.3 the iveco? or for the other? for example 6.2, and in particular the scania do you know something?

[todos]

Hello Todos, but only applies to the ms6.3 the iveco? or for the other? for example 6.2, and in particular the scania do you know something?
only the ones that you mentioned..

[Fabiuz]

I read the 24C16 without dissaldarla, scodificata and the means is the party.