the clarification.

[Nightwing]

Question: but if a file is read in and saved with BDM, Kess, Mpps... etc. Pu? only be used with the respective Hardware bed or pu? be rewritten interchangeably with all types of Hardware?

[giarras]

usually it pays to read and write with the same tool,however ? can also use different instruments, but you have to always pay attention to the size of the file xch? all the serial nos read the same size,then there are ecu's that I allow to read in the serial, and then you always need to bdm that you can also write in the serial controlling species x mpps that the file nn needs to be cut.

[legendaryslave]

the rule says what is read write different tools that can read different areas of the map

[msport (exil77grande)]

apart from the excellent explanation of giarras I would recommend that you ask in each case if you have doubts why not you can do the same reasoning generalizing.

[munro]

I would not put a veto on every thread...? I would like to say that,according to me and corregetemi if I'm wrong,a backup bdm read with any tool can? be written with any tool..

[giarras]

I would not put a veto on every thread...? I would like to say that,according to me and corregetemi if I'm wrong,a backup bdm read with any tool can? be written with any tool..

munro,nn ? just like that,in fact, msport has done well to point out, I have been very generic.

[munro]

giarras you want to tell me that a backup bed in the bdm with kess v2 to es can be written with a rooster v2??

[munro]

always in bdm obvious...

[msport (exil77grande)]

giarras you want to tell me that a backup bed in the bdm with kess v2 to es can be written with a rooster v2??

kess does not have the bdm, but there was the old bdm alien, which in some cases can take a file of a different natra, and vice versa,sometimes even if they change the size, you can unify and vice versa,as I have already written, it is always better to ask specifically why not a speech that applies to everyone.

[panterargento]

I msport,

[chicco]

A backup bed in the bdm with gallo2 has a length, cmd, another with ktag still another, and also the micro individually are not read with the same length.

[Nightwing]

usually it pays to read and write with the same tool,however ? can also use different instruments, but you have to always pay attention to the size of the file xch? all the serial nos read the same size,then there are ecu's that I allow to read in the serial, and then you always need to bdm that you can also write in the serial controlling species x mpps that the file nn needs to be cut.

Doubt me ? arose yesterday qndo I have uploaded the files of my 159 (bed kn Mpps) in the section database ori and I realized that alkuni files reported anke the type of reading bdm and kess.
Then kn Mpps nn there should be no problems.
Thank you all for the answers:)