Sign in

View The Full Version : creating cable boot


giarras
03-07-2012, 20:41
how to build a cable boot with about 5 euro
sportknight
03-03-2013, 20:37
a strange curiosity?,it is also good for mpps and will work on all the units? why? I read on some other values of resistance and not c'? no diode between the two can...
succdfrutt
06-03-2013, 20:04
giarrass but this cable ? to be able to read what? ? only to be able to make a diagnosis cn other software?
frantik3
06-03-2013, 23:24
how to build a cable boot with about 5 euro


taken from cmd hahahahah
giarras
16-03-2013, 15:24
taken from cmd hahahahah

only at that place you pay...if you do ,what you less than 5 euro..all qu
hackgen
24-03-2013, 11:45
Hello Giarras, as I wrote in a topic I can not more to read nor to write the map of my a4 2007 edc16 via serial,
with this cable, I can solve? Hello, Thanks


how to build a cable boot with about 5 euro
succdfrutt
28-03-2013, 11:10
but excuse my ignorance... but boot x what? start x to do what?
Thanks...
hackgen
28-03-2013, 11:45
From what I understand, the mode? boot and a particular mode? access to the ecu, which you can use in certain cases.

but excuse my ignorance... but boot x what? start x to do what?
Thanks...
zioweb
15-11-2013, 15:45
but to boot for such as ecu?? mica will go? well for all...
sportknight
15-11-2013, 17:27
all of those use the k line,then if there colleagues also the can is also good for the can...
zioweb
15-11-2013, 20:35
Mucho interesting
giary74
16-02-2014, 09:56
all of those use the k line,then if there colleagues also the can is also good for the can...

I would not say nonsense, but this cable you could use to read and write in the boot of the IAW 59F?
sportknight
17-02-2014, 09:12
of course you can
micheleyr6
friends...I understand that puts in the boot, the ecu, but kindly explained how to use this cable??

and what ecu does it work?
ugoboss
hello,you can use it in all of those ecu's where you need a cable to read to tour, almost all of the interfaces that you buy already have the cables, but many don't have the attack the obd, this is similar to the one that they give you with the MPPS v18, what is more, it has a switch to power or not the ecu, even if many found them to be wrong with the power supply to the contrary, namely, fuel always the ecu and when you turn on the power switch to supply power to the connected instrument (usually should be the opposite), however, this and a cable, always useful.
micheleyr6
thanks boos always very helpful...
if I have understood correctly then this is when to the a interface with the obd and you want to read a ecu on the bench in boot mode...
I believed that you could put the ecu in boot from the diagnostic socket,...
ugoboss
hello, if you want to read the ecu on the bench by putting it in bootmode without opening it you have to use the technology bench that have become all the interfaces of the latest generation as well as the official clone that I know ( but I am not no one) ec only the KTM bench, I have and it works fine.