New Smart 1000 sucked

[goku]

Hello guys, someone I'm coming! With what we read/write control unit of this car,..?.

[goku]

I'm coming= sa.. Damn ipad..;)

[angel]

Also of interest to me would I have any to do.. but the ecu mounts? now all I have on hand.

[admin]

It is in the boot st to the tour you need to open it and solder the two resistors if you need I'll post the picture

[admin]

Oh, I forgot, and a Bosch M7.7.0

[angel]

Then with the cock you can read/write?

[msport (exil77grande)]

Then with the cock you can read/write?

with the v2 I guess.

[pinotec]

you can also make it with mpps,flashteck,mag2,kessv1,piasini in the boot
a piece of advice... you need to open the ecu't even a backup of the e2p
especially if you use mpps

[angel]

Great then..thanks for the info

[goku]

With Mpps does not.. Tried .. Only 600 700 800 or 1500 d

[pinotec]

With Mpps does not.. Tried .. Only 600 700 800 or 1500 d
you are doing ..you have to select generic and model of the processor of the ecu

[goku]

Ok.. We tried again.. Ce the risk of the block with the Mpps that tips the bakeup?

[pinotec]

is there a risk that it corrupts the e2p

[admin]

The exact laws before the 2ep and you're safe

[goku]

The exact laws before the 2ep and you're safe

Mmmm... Too complicated for my current knowledge.. For the moment desisto..

[munro]

to read the e2p you have to make a back up.....

[angel]

Hi, out of an old discussion, I should read this ecu to the bench with Gallo v2 someone has the links? and the protocol to use ?
Thanks

[angel]

Ah ok found them, but I had seen