copy paste with ECM Titanium

[ago27]

hi all guys, I have a small problem, that after so many attempts I can not solve, for example, to change the hot start on the edc 16 vag group you have to take the three curves of the next map, and copy them on the map above, in practice we need to copy the address 0F0836--0F0860 in 0F0758--0F0782 Now the question, and as you proceed to copy the curves indicated with ECM titanium? What are the steps the more simple to do this copy paste????Thanks to those who help me......

[magi1984]

select with the right mouse addresses to be copied, for example by 0F0836 to 0F0860 , then go to the copy key data in the upper right, and select it
then with the mouse, you move to the address of starting where you want to paste the data, and do CTRL+V to paste

[ago27]

0key magi984 thank you it worked, only that that the address where to copy the second map according to me was from 0F0758 to 0F0784 and not 0F0782 as I had read on the forum to the indicated section.....

[msport (exil77grande)]

0key magi984 thank you it worked, only that that the address where to copy the second map according to me was from 0F0758 to 0F0784 and not 0F0782 as I had read on the forum to the indicated section.....


magi has indicated the procedure to make a copy and paste to completely address the thing is relative to the file in question, and not always are the same files.

[magi1984]

exact, the addresses change from map to map...

[abberello]

many times you will make a mess for a copy and paste done haphazardly!