file size sid803 psa

[pinotec]

Hello all, does anyone know the size of the file to write by obd with kess v1 sid803 peugeot?
currently, I write with the 1255 and the file of micro and 452kb,but if I try to load it with kess.. tells me that the size of the file, and incorrect
someone of you has ever written with this tool ?

[msport (exil77grande)]

I use kess v2 now I can't remember exactly the size of the file but if you want all the data and require the file ori to the alien, and you should go quiet.

[pinotec]

thank you for the availability msport,but don't worry, the x files, mine was just a curiosity,in the end, all the tests I did the always written with the old-1255..even if sometimes it fails to write... close it and I open the prog and the rewrite without prob..so as they say.. do not leave the old road ..if you don't know the new one :)

[msport (exil77grande)]

ah ok, however, available.

[giarras]

these are the two files
1 mb
1 448 kb

1l first should be kessv2
the 2 magpro or kess1

if I'm not mistaken.

[pinotec]

at the moment I still can't download the file..
anyway the id to me by' and' :
HW:9655041480
SW:9656061180
SW:9663609680

[giarras]

ok when I return home I can see if I have what you need in my database cmq nn ovebbe be difficult to find.

[pinotec]

thanks giarras ..luckily not urgent,peche anyway the file to write it with the 1255 there ..but ,it may be useful to the same

[giarras]

ok when I go back to palermo I see in the meantime, you may want to check the ones I have posted before when you get to 50 of the mess.

[meccano85]

usually ? from 1mb instead of the sid 803a are 2mb

[pinotec]

the flash and 1mb ,but the maps are in the micro.

[ago27]

I confirm 1 mega

[Team electronics]

I confirm 1 mb

[gezame]

the flash and 1mb ,but the maps are in the micro.

Hello
Exato.
The longueza you leggui in the obd, dependent on interface 448k or 452k, but I'm always reading micro, where are the maps.

[pinotec]

Hello
Exato.
The longueza you leggui in the obd, dependent on interface 448k or 452k, but I'm always reading micro, where are the maps.

yes, I know'
the problem and the kess2-mag2-flashteck ,who do not accept files from 448k or 452k to write this ecu

[gezame]

Hello
A, ok, with kess2-mag2,etc, only you can do in the BDM.

[dvdtuning]

Inveve on sid803a the magpro should read it properly from 2 mega?

[gezame]

Hello
Yes, correct, 2 mega, but only for the sid803A.
For the sid803, no.

[spiki_x]

For the sid803 the program and in the processor.

If you read it in the bdm with the rooster on the file of the processor, and a bit small to read with the BDM1255 , because 1255 law, the "shadow block".....

The cock I upload both files without problems