Protocols Bosch EDC16 C39 Iveco Daily

[gimarras]

good evening,
I have to read a BOSCH EDC16 C39 0281 012 193 processor-MPC-562m but I have the protocols of my tool who read the versions with the MPC 555 and 556. Seen attacks where to solder are the same, I might try to read it using the mentioned protocols? Has anyone ever tried it? Risk cooking the ECU or just failure to connect.
Thanks

[blackwolf76]

edc16 bdm are all the same...

that the also read from the socket with the tools and more common.

[dj_piex]

edc16 bdm are all the same...

that the also read from the socket with the tools and more common.

Attention that many Iveco reads only a part of the table flash in the obd,and you risk modifying and rewriting have problems after because it changed in the middle', just to be safe you need to do a full read to tour and then write to a file full BDM readed by obd, to ensure they write all the zones tables.. ;)

[gimarras]

Thanks,
I have connected the bdm, and actually recognized the protocol, even if it appeared not on the ones available. Read and wrote regularly.