Turbo pressure and Limiter pair SID 803 FIAT Scudo TD

[gimarras]

Hi, I am attaching the map fiat scudo TD with SID 803.The machine error turbo pressure: I have perhaps exaggerated with the increments? I try to decrease by 10% . Can you go? Are also not sure of the addresses of the torque limiters. Could someone indicarmeli? Thanks. I attach the file ORI and MOD HW 9666931180 , SW 9665100380.
thanks

[lsdlsd88]

I still can't download the file, but from your question I ask you you increased demand turbo of MORE than 10%?? I know the maximum is around 2.43 limiter at 2.58. so according to me leaves ori the limiter, and increase it to brighten to a maximum of 0.15 bar

[gimarras]

OK . Thanks lsdlsd88 :I lowered the press. the turbo +8% of the original. In the map with ECM I can't seem to locate the torque limiters. Can anyone give me some tips?

[lsdlsd88]

4BA22 and following the 16x16 maps pedal (do not exceed max value 32768=100%)
5C140 12x16 lim fumes vs MAF
69F1C and 6A7C4 20x1 lim couple

if you can always do a degree, do not go overboard with the increases if you do not already have the file tested x these engines.

[gimarras]

With the ECM in these addresses I find curves that do not seem relevant to what I have indicated. The limiters, for example, have a strange shape. The other maps these addresses will end up in the middle of the curves. These address are for the 2d ECM or something else? Furthermore, they are not practical hexadecimal. Despite having lowered the prex turbo continues to go in the recovery, not to the low gears but in the fifth under stress. Could be the amount of diesel?

[lsdlsd88]

Hi we may be looking at a different file because I found it on the net...

Certain that if you make maps deceived by raising the time you have an overboost. Especially if you have not raised the soi (advances).

[gimarras]

OK, you've been clear: I try to give more diesel.
Sin for doubt about the torque limiter, if you don't release I think that all of the changes are unnecessary.
thanks

[lsdlsd88]

I've truly said to the contrary.
Get up with the times -> an overboost.
Time ori -> nothing an overboost .

In the second case, if you want to inject in, the more you have to ask for it! Then pedal, lim iq , smoke, torque, etc...

Tomorrow I hope to be able to download it so I'll tell you better.

[lsdlsd88]

lifts more maps the pedal and not with the same percentage everywhere! keep the maximum value (32768), even to rpm higher. then I did not understand why you have made only some, there are 11.. then lift up the 2 lim torque to 20-25, and the lim smoke a little bit (5-10%), and put the original maps duration (time)..

[lsdlsd88]

P. S: I don't understand why you say that you are not with the addresses, you see different things?

[lsdlsd88]

mannagg........

[gimarras]

Can't download.
As soon as I can I try with the directions that you gave me then I'll let you know how it ends.
In the meantime, thanks.