prompting for a panda 4x4 1.1 mpi8v

[tac89]

salt I know that this is not recommended because of the low if not very low performance to reach but I was wondering if someone could give me a hand to find the addresses to the ecm from strange things....and winools I open even the maps of potential there I am, beating by 2 days
to the ancient split
injection zoned
and at full load
the pedal and the engine load optimal
torque limiter
the rev limiter
and a decode iaw 4af p4 /hw204
I attach ori and modified since I made a scodifica total with a program that has changed a bit of things

[Andrea1]

Can you tell me the hw and sw? then, if we find a solution for the scodificare, I am going to try the file that I had made years ago for a 600 with the 1.1

[tac89]

46817814
iaw4afhw204
18080er
4afp4 ..
. ..
11 02 2002
.01.9 5af

[tac89]

No one knows me on the addresses

[Andrea1]

4e27e the rev limiter
Unfortunately, they are a bit messed up these days when I get a moment I'll give you the maps

[Andrea1]

4845C advance split (second ecm)
4D7C0 injection choked (according to your ecm)
4E150 injection full load

[tac89]

Tonight I look at but if they are the same addresses that my ecm curves just don't make sense to me, I hope for the best

[Andrea1]

The beginnings of the map that I posted them, I searched manually the name "according to the ecm" I have used it because if you open a file where the driver of the ecm work the curves will be identical. The values that come out for the injection I do not know exactly to what you refer, but I went to try it with small increments and with a diagnosis in hand. You'll see that with a little work you will get satisfactory results for a naturally aspirated small.

[Andrea1]

You managed to give it a prompting?