Audi tt 2.0 tfsi 200cv med 9.1

[Romanoalessio]

Good evening to all,

I have a small problem with my audi TT, tonight I read the file ORI for remap, load it into the ECM and I search the driver (A519_549) until here all ok, but when the selection and return to the main page I have nothing, does not give me any map to start editing, but if I open the file in 2d I can see everything, but apparently it seems a little strange (I mean, this is the first time I work on an ecu like that)and I don't want trouble!!!!!! are in your hands!!!

[cinqueturbo]

Could be due to the fact that your ECM, and "Free" and not ORI ?

[cawadany]

Let it go. It is not the right software for the ecu.

[Romanoalessio]

Yes, my ecm is free! But for the rest I can map almost all of the cars that I captain! I also thought that it was for that :-(

[Romanoalessio]

Cawadany you say that is not the sw suitable because it is free, or that ecm is not suitable for this type of ecu? I tried it with winols but before putting the hands I would like to study for a while the operation!!! I am here I make you another question in their computers, I have the item tool with three settings (0-1-2 it comes to the settings of the sw or ecu?
How about if I try to post the file ori maybe that is a error reading that the ecm fails with the driver?

[Fede87]

with ecm free is difficult to map these ecu's, it takes winols with damos or maybe ecm original (so that you find the parameters with the driver)

the problem that prevents you from seeing the parameters is due to the driver of your ecm.

[Fede87]

if their computers gives you 3 different modes of tool means that there are med9 with different hardware. you have to see what is one of your ecu. but this if you write by obd you must not import