scodifica partial 5sf8 ecu new 500 2008

[sno74]

I have to make a scodifica partial on new 500 of 2008, I wanted to know if ? can do so via the ep2 or only with the decoder, and if anyone already? the usa what can I buy or the various decode that exist in the market hello and thanks....

[giarras]

the scodifiche I will never be passionate anyway, I think you have 2 alternatives:

or....EEPROM ST10F280

or...with a tool dedicated to the mandi in the boot and not disaldi nothing..but first see what advise in the forum.

[sno74]

I wanted a pattern for the boot if someone has already? open this ecu......

[msport (exil77grande)]

If I am not wrong I have done long ago one of these and I tell you that it is very complicated and requires emulator is very special and even rare to try.

[Infineon]

L eeprom is in the micro-ST, the laws in the boot and re-enter the virgin, should I have the partial file... Which tool do you use ?why? change the size of the file

[msport (exil77grande)]

ah now I remember, in my case it was total so I guess for the partial solved more easily.

[Infineon]

eccolol'I found it!

[sno74]

I have mpps cock and kess v1 clone, it seems to me that all 3 read bott I would like the instructions seen that the readings in bott and for me the first time, from what I understand I have to open the ecu and then do the two bridges, but the bridges and better to do with strength right then to connect to reading.....

[Infineon]

Every hw has his own system to put in the boot and reads the file with a different size

[sno74]

Ok but you are with what you read in the bott.....

[Marting]

can you immo off this ECU ?