remap Alfa 156 1.8 TS '98

[biandrea]

Hello all,
I have the Galletto V54, and quanrdando fgtech-driver-list-car.pdf has this car Bosch M 1.5.5 and it seems you can flash, and then the exhaust, modify it and then load to the ecu, right?

[munro]

Serial not do this..
Should be done by putting the ecu into boot mode..

[biandrea]

Serial not do this..
Should be done by putting the ecu into boot mode..
oook, so I have to put in mode "boot mode", it is not that you love this procedure, but if you do so...

it connects so?
KLine = P11
-12V = P23, P29, P33
+12V = P8, P17, P18
Pin 10 = Boot Mode (GND)

[biandrea]

I made confusion, I hope that you see

[sergiot]

pin 10 goes to +12v

[biandrea]

pin 10 goes to +12v

Ok, thanks
so it's not a mass, but at 12V the P10 and also the P23, P29, P33, however, put to ground?
KLine = P11
-12V = P23, P29, P33 (GND)
+12V = P8, P17, P18
Pin 10 = Boot Mode (12V)

[msport (exil77grande)]

I made confusion, I hope that you see

this forum has a regulation that I invite you to read and some of the rules mentioned, there is the entry, not paste a link to external sites and to insert material, there is the advanced feature that allows you to attach what you want and can then see only the users that have more than 80 messages thanks for your collaboration.

[biandrea]

Then after a stop I re-started work on remapping, I've run the connection to a control unit of a twin to the 156 1.8 TS for practice and to avoid blocking.
With the program I entered and I read the Left 4 keys:
-ECU data
-Read the File (not clickable)
-Write File
-Exit

I read the HW and SW, the kmt paths, data mapping and how many times it has been mapped.
Only read the data but saricare the file I can not, the ecu must be in BOOT mode while placing their cash by checking out the pdf in the Wingnut should I also open the ecu and solder the white wire to a certain pin, I have to do so?

My goal would be to download the data of my own, and edit the map and put them in another and then use it, the miles I would not touch it, if ... things go wrong I always have my original...

[biandrea]

I do a copy paste of the data, and match by connecting both to ODB that by plugging in the BDM
Bosch HW: 0261204732
Bosch SW: 1037359282
Fiat HW: 46554831
The ECU is not encoded
Max KM: 202134.55 km
Date progr.: 19-08-1998
Max Revs: 7320
Programming: 1
Crc Errors: 0

however, we are always there, I'm not going into mode to download the file...
I take a file to the 156 1.8 in the internet, and work on that?