hello to all!
I wanted to ask kindly if someone can tell me which interface I can read and write on the ecu this wv polo 1.2 12valvole 3-cylinder petrol CGPA of 2009, (the place the photo of the controller below). thanks.
IMG_3621.jpgIMG_3621.jpg
hello to all!
I wanted to ask kindly if someone can tell me which interface I can read and write on the ecu this wv polo 1.2 12valvole 3-cylinder petrol CGPA of 2009, (the place the photo of the controller below). thanks.
IMG_3621.jpgIMG_3621.jpg
What do you hope to achieve by mapping this car??
that interface you have at your disposal?
this manual shall be read in both serial and in the boot
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Don't lose the time, the cv out is not pull out of this engine.
Hello, and thanks for the reply, I'm actually working on a project to transform it from the intake to the turbo, I have mpps v13 and I wanted to know if I can work on it or do I need some other interface, galletto or kess, you are a novice with the change of the control units and before any damage was done I wanted to ask advice thanks.
then what can I use?
Gallo2 Kess, K-tag, etc.
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Thanks, being a beginner in the field what you recommend me?