Kia Sportage 20. IMMO off Zex

[gimarras]

good morning guys,
I'm trying to SCode a Ze montata SEL mounted on an old KIA Sportage 20 TD.
I have the mod file that I attach and that I tried to rewrite on the chip. If I write it as 93C56 when I go to read it again it is different, while if I write it as 93C46 it is the same but it does not work even if I disconnect the immobilizer control unit.
Am I wrong or is the IMMO file not good?

[ugoboss]

with what the file was modified, I looked on ecuvoni Sol solution and from these explanations about it,

Programming the EEPROM OKI M951G
Only for KIA SPORTAGE 2.0 TD

Read and write with UPA-USB Programmer as 93C56 16bit

Only in case of non start problems,
reprogram the eprom again
and cut pins 54 and 62 from the ECU

[gimarras]

file processed with ecuvonix but the doubts are two, if the file is OK and how come if I write it with UPA as 93c56 , rereading it is different. I'll try to cut the pins. thank you boss