Discussion: edit elm 327

Regulation read, thanks msporteven if I feel a little restrictive, but anyway I adapt myself.

edit antonioantonior, then regardless whether the pin 6, pin 14 should be everyone for themselves places in mass by putting in series to each of them, the resistance and the capacitor in series, I'm sorry, but by doing so the output can (not having yet open the interface rimarrenne connected to pin 6 or pin14 ?

Originally Written by boat

Regulation read, thanks msporteven if I feel a little restrictive, but anyway I adapt myself.

edit antonioantonior, then regardless whether the pin 6, pin 14 should be everyone for themselves places in mass by putting in series to each of them, the resistance and the capacitor in series, I'm sorry, but by doing so the output can (not having yet open the interface rimarrenne connected to pin 6 or pin14 ?

I confirm what is written, stating that before doing this you need to remove the resistance that c'? in the source between pin 6 and pin 14. Of course, these two pins will always remain connected to the can bus of the vehicle, the connection described (resistor and capacitor) andr? then, in parallel with the can line coming from the vehicle.

ELM327

edit

ELM327 )

elm327 elm327 edit

Many greetings
Thomas

I attach a couple of photos of my interface.

edit

elm327 elm327

Hello I send you the photos so you give me some advice

edit