Discussion: edit elm 327

Regulation read, thanks msporteven if I feel a little restrictive, but anyway I adapt myself.

Return to the edit ,excuse of' my ottusit? dear antonioantonior, then regardless whether the pin 6, pin 14 should be everyone for themselves places in mass by putting in series to each of them, the resistance and the capacitor in series, I'm sorry, but by doing so the output can (not having yet open the interface rimarrenne connected to pin 6 or pin14 ?

Originally Written by boat

Regulation read, thanks msporteven if I feel a little restrictive, but anyway I adapt myself.

Return to the edit ,excuse of' my ottusit? dear antonioantonior, then regardless whether the pin 6, pin 14 should be everyone for themselves places in mass by putting in series to each of them, the resistance and the capacitor in series, I'm sorry, but by doing so the output can (not having yet open the interface rimarrenne connected to pin 6 or pin14 ?

I confirm what is written, stating that before doing this you need to remove the resistance that c'? in the source between pin 6 and pin 14. Of course, these two pins will always remain connected to the can bus of the vehicle, the connection described (resistor and capacitor) andr? then, in parallel with the can line coming from the vehicle.

Hello guys sorry if I repeat the question, but I understand I like and what to do to change the ELM327, the CIO? WHAT TO BUY BETWEEN THE RESISTOR AND CAPACITOR, AND WHERE TO SOLDER, MAYBE IF C'? a pattern or picture to follow the steps to keep in mind that I am new to writing and I can not open any file, in any case, thanks to all

with this modification, that the privileges you would have?

I just opened my ELM327 Bluetooth ? already changed )

Despite my elm327 is gi? changed.. when I try to log in to the service reset in the service, tells me it's not ? possible for an error with the elm327 interface. I noticed when doing the test of the interface through the options *********** tells me that this type of interface does not support any protocol type CAN. It is possible, in spite of the change..... ???

Many greetings
Thomas

I attach a couple of photos of my interface.

In the circuit from a face you notice the resistance r2 and the capacitor c2, the other side of the circuit the same components R1 and C1, as measured with the testesr resistance, and ? 100 ohm, and are connected, respectively, to the scheme of the amendment, to pin 4 and pin 6 connected to ground with a resistor and a capacitor in series. Why? it doesn't work ?

I change often elm327 and honestly I can never replace the resistors but I delete only, and so far all the versions that I changed to work perfectly without causing damage to the elm327 same and, above all, without causing damage to the ECU. Unfortunately I do not have system enough to see your attachments, but it will be? happy to help also for private messages. hello tuttiiiiiiiiiiiiiii

Hello I send you the photos so you give me some advice

I elm I have to buy what you advise me who uses clearly appropriate to make this change, I thought I take the usb I fear that the Bluetooth I get in conflict with other tools that I always use Bluetooth.......