hi guys, I need your help to understand how it is managed the turbo in this ecu(me7.9.10).
so far I have found that the characteristic curves of the compressor and the turbine, but I still don't know how to act to increase the pressure...
in particular, I found a third limitation that could express the relationship between the pressure of the incoming and outgoing from the compressor(mappa3 attached)
do you have any advice?mappa3.jpg155-165cv.rar
in general, on this ecu there are
2 limiters turbo 8x1 and 2 limiters turbo 16x1
1 an overboost Map 10x14
2 Maps Management Turbo 10x10
1 Map Turbo Pressure
when I'll be able to reach the 50 posts I download the file and I'll give you a hand
Attention turbines that are gentle enough not to increase too
map turbo pressure of not more than 0.1 Bar to increase
si0.1 should be enough... I spotted a p? maps of the turbo for? I can not understand what manage... What's in the axles ... You have a damos or something?Originally Written by mavaila1972
no damos I made some, and with a little experience, you understand, read the post above where I said the names of the maps tap the limiters turbo and map pressure turbo the other hands ori if you do not know the operation
on the maps of the turbo what is the parameter in the map ? And the axes? If not, I don't know how to change the map...
just reached the 50 post discharge, ori and I'll give you some tips to map it
the map of the butterfly did you find her? ..
not the one in function of the temperature... First I have to find the map of the pressure of the turbo... You are aware?
you can find maps opening butterfly
Write permission
Quote